Bore should be 5/8 inch. Instead of a hole, there was a whopping 1 mm for a small one. In addition, the keyway was too small in both width and depth. Now a kicker, the keyway has been cut down the middle, leaving one side lower than the other. I saved the best for last, the length of the keyway was cut diagonally to a square. How does someone do that? In the end it's pure crap. Well to be fair it might just be my bad luck but everything else is fine. Much luck!
Bearing 608- ZZ1MC3E (8x22x7) NSK//80018
4 Review
👜 Wheels Manufacturing Ball Retainer Bag: Convenient Storage and Protection for Your Ball Retainers
6 Review
FKG 99502HNR Bearing Width Pre Lubricated
5 Review
Enhanced Performance Sydien SCS12UU Bearing Bushing Diameter for Precision Machinery
4 Review