Header banner
Revain logoHome Page
Russell Ross photo
Guatemala, Guatemala City
1 Level
763 Review
60 Karma

Review on Pack Of 4 WINSINN 40Mm Blower Fans 12V With Dual Ball Bearings, Ideal For 3D Printers - 40Mmx20Mm 2PIN Connectors by Russell Ross

Revainrating 3 out of 5

The quality on these isn't as high as other products I've gotten from WINSINN

These fans are loud and seem to be lower quality in general. I've used fans from 3010 to 5015 purchased from WINSINN and never had an issue until these. They are for some reason louder and the soldering was very poor. The black wire was holding on by a thread and a slight tug on the red wire and the whole thing including the pad came off.I'm pretty disappointed in these. Hopefully it was just a bad batch.

Pros
  • These fans are specifically designed to operate at a low noise level, which is important for applications where noise can be an issue
Cons
  • The fans may have a risk of causing injury or damage if not handled properly